Compare Papers

Paper 1

A hardware-native time-frequency GKP logical qubit toward fault-tolerant photonic operation

Tai Hyun Yoon

Year

2026

Journal

arXiv preprint

DOI

arXiv:2602.14461

arXiv

2602.14461

We realize a hardware-native time--frequency Gottesman--Kitaev--Preskill (GKP) logical qubit encoded in the continuous phase space of single photons, establishing a propagating photonic implementation of bosonic grid encoding. Finite-energy grid states are generated deterministically using coherently driven entangled nonlinear biphoton sources that produce single-photon frequency-comb supermodes. An optical-frequency-comb reference anchors the time--frequency phase space and enforces commuting displacement stabilizers directly at the hardware level, continuously defining the logical subspace. Timing jitter, spectral drift, and phase noise map naturally onto Gaussian displacement errors within this lattice, yielding intrinsic correctability inside a stabilizer cell. Logical operations correspond to experimentally accessible phase and delay controls, enabling deterministic state preparation and manipulation. Building on the modal time--frequency GKP framework, we identify a concrete pathway toward active syndrome extraction and deterministic displacement recovery using ancillary grid states and interferometric time--frequency measurements. These primitives establish a hardware-compatible route for integrating the time--frequency GKP logical layer into erasure-aware and fusion-based fault-tolerant photonic architectures.

Open paper

Paper 2

Tradeoffs on the volume of fault-tolerant circuits

Anirudh Krishna, Gilles Zémor

Year

2025

Journal

arXiv preprint

DOI

arXiv:2510.03057

arXiv

2510.03057

Dating back to the seminal work of von Neumann [von Neumann, Automata Studies, 1956], it is known that error correcting codes can overcome faulty circuit components to enable robust computation. Choosing an appropriate code is non-trivial as it must balance several requirements. Increasing the rate of the code reduces the relative number of redundant bits used in the fault-tolerant circuit, while increasing the distance of the code ensures robustness against faults. If the rate and distance were the only concerns, we could use asymptotically optimal codes as is done in communication settings. However, choosing a code for computation is challenging due to an additional requirement: The code needs to facilitate accessibility of encoded information to enable computation on encoded data. This seems to conflict with having large rate and distance. We prove that this is indeed the case, namely that a code family cannot simultaneously have constant rate, growing distance and short-depth gadgets to perform encoded CNOT gates. As a consequence, achieving good rate and distance may necessarily entail accepting very deep circuits, an undesirable trade-off in certain architectures and applications.

Open paper