Compare Papers

Paper 1

Approximate level-by-level maximum-likelihood decoding based on the Chase algorithm for high-rate concatenated stabilizer codes

Takeshi Kakizaki

Year

2026

Journal

arXiv preprint

DOI

arXiv:2601.18743

arXiv

2601.18743

Fault-tolerant quantum computation (FTQC) is expected to address a wide range of computational problems. To realize large-scale FTQC, it is essential to encode logical qubits using quantum error-correcting codes. High-rate concatenated codes have recently attracted attention due to theoretical advances in fault-tolerant protocols with constant-space-overhead and polylogarithmic-time-overhead, as well as practical developments of high-rate many-hypercube codes equipped with a high-performance level-by-level minimum-distance decoder (LMDD). We propose a general, high-performance decoder for high-rate concatenated stabilizer codes that extends LMDD by leveraging the Chase algorithm to generate a suitable set of candidate errors. Our simulation results demonstrate that the proposed decoder outperforms conventional decoders for high-rate concatenated Hamming codes under bit-flip noise.

Open paper

Paper 2

Tradeoffs on the volume of fault-tolerant circuits

Anirudh Krishna, Gilles Zémor

Year

2025

Journal

arXiv preprint

DOI

arXiv:2510.03057

arXiv

2510.03057

Dating back to the seminal work of von Neumann [von Neumann, Automata Studies, 1956], it is known that error correcting codes can overcome faulty circuit components to enable robust computation. Choosing an appropriate code is non-trivial as it must balance several requirements. Increasing the rate of the code reduces the relative number of redundant bits used in the fault-tolerant circuit, while increasing the distance of the code ensures robustness against faults. If the rate and distance were the only concerns, we could use asymptotically optimal codes as is done in communication settings. However, choosing a code for computation is challenging due to an additional requirement: The code needs to facilitate accessibility of encoded information to enable computation on encoded data. This seems to conflict with having large rate and distance. We prove that this is indeed the case, namely that a code family cannot simultaneously have constant rate, growing distance and short-depth gadgets to perform encoded CNOT gates. As a consequence, achieving good rate and distance may necessarily entail accepting very deep circuits, an undesirable trade-off in certain architectures and applications.

Open paper